A.IR Shield ESP8266/ESP32 TRx

A.IR Shield ESP8266 TRx with Wemos D1 Mini

Where to purchase

AnalysIR's IR Shop

Data Sheet

The data sheet can be found by clicking here

Loading Firmware

You will receive a csource copy of the firmware after your order is shipped. The firmware has an option to use a serial USB connection to AnalysIR or a WiFi connectiom (only when on the same WiFi network).

SerialUSB Configure the definition for useWIFI as false to connect via serial USB.

WiFi Configure the definition for useWIFI as true to connect via WiFi. In addion you must also configure the definitions for SSID (mySSID) and WIFI password (myWiFiPassword)

The default port for communicating with AnalysIR is 9449 (declared via webServerPortAnalysIR)

AnalysIR Setup

Required for WiFi only - First make sure that the IP Address and port numbers for ESP8266 are configured correctly in the AnalysIR.ini file (Use Menu->FIle->Explore from within AnalysIR to locate the correct directory) Select either A.IR Shield ESP8266 WiFi (CTRL+ALT+6) or A.IR Shield ESP8266 Serial (CTRL+ALT+7) from the Source Menu.

Inserting Shield into Wemos D1 Mini

Make sure the the 2 IR Leds are at the same end as teh PCB antenna on the Wemos D1 Mini (opposite end to the usb connector). All pins of the shield should be inserted into the female headers.

LEDs

There are 2 LEDs. The first is located on the Wemos D1 Mini (usually blue). This LED is on the same IO pin as the IR send pin of the shield. After start-up it will always appear on. If this is an issue, it is relatively easy to remove this LED with a soldering iron. The second LED is at the front of the shield and after startup will briefly flash red as IR signals are transmitted. However, when both IR power jumpers are installed, the LED may not flash or be very dim. This is normal behaviour and is related to the use of the red LED as part of the constant current driver circuit for the IR LEDs.

== Pinouts ==