Getting Started: Difference between revisions
Jump to navigation
Jump to search
mNo edit summary |
mNo edit summary |
||
| Line 10: | Line 10: | ||
* If you ordered the SerialUSB adpater, then it will be compatible with KontroLIR. | * If you ordered the SerialUSB adpater, then it will be compatible with KontroLIR. | ||
* For CP2101 based SerialUSB adapters, drivers can be downloaded from [https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers CP2102 Driver download] | * For CP2101 based SerialUSB adapters, drivers can be downloaded from [https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers CP2102 Driver download] | ||
* For initial usage, it is best to power KontroLIr with the SerialUSB adapter, until you are ready to use with batteries. | |||
* Make sure to have 2xAAA batteries availble befor you plan to start using KontroLIR as a remote. | |||
'''''[[KontroLIR - Arduino compatible IR remote control|> KontroLIR Home]]''''' | '''''[[KontroLIR - Arduino compatible IR remote control|> KontroLIR Home]]''''' | ||
Revision as of 04:45, 6 October 2019
Follow this section the first time you get your KontroLIR remote control.
Checklist
- Make sure you have s SerialUSB adapter which has a pinout for Vcc, GND, Tx, Rx and either DTR or RTS. (Note: some adapters do not have the DTR/RTS pin available, which is required for uploading firmware)
- Make sure you have a USB cable to use with the serialUSB adapter.
- Double check your order to establish if you have one or more of the options (EEPROM or dual IR Receivers)
- If you ordered the SerialUSB adpater, then it will be compatible with KontroLIR.
- For CP2101 based SerialUSB adapters, drivers can be downloaded from CP2102 Driver download
- For initial usage, it is best to power KontroLIr with the SerialUSB adapter, until you are ready to use with batteries.
- Make sure to have 2xAAA batteries availble befor you plan to start using KontroLIR as a remote.