DIYIR - Soldering Kit

Where To Purchase

Visit AnalysIR's IR Shop where you will find this and a range of similar Infrared solutions. You can also purchase via our Tindie Store

Data Sheet

The data sheet can be found by clicking here

Assemly Instructions

Follow the step by step guide DIYIR Assembly Instructions

Jumper Settings

JP1 - Insert this to increase IR Output power by a factor of 2x. JP2 - Set to 5V for 5V opertion and to 3V3 for 3V3 operation. (In 3V3 mode one of the IR emitters is removed from the circuit) Note, it may be possible to operate both emitters @ 3V3 by powering from 3V3 and setting JP2 to 5V mode, However, the red LED may not visibly blink when a signal is being sent. Always make sure to power the module from the same volatage as the locic level of the system you are connecting to (5v->5V or 3V3->3V3)

Use with IRRemote

DIYIR can be used with IRremote and othe Libraries(E.g. IRLib) by connecting as follows:

DIYIR Wiring

The image shows wiring for %V opertion. To use with 3V3 set the position of JP2 accordingly.