Getting Started: Difference between revisions

From AnalysIR WiKi
Jump to navigation Jump to search
mNo edit summary
mNo edit summary
Line 10: Line 10:
* If you ordered the SerialUSB adpater, then it will be compatible with KontroLIR.
* If you ordered the SerialUSB adpater, then it will be compatible with KontroLIR.
* For CP2101 based SerialUSB adapters, drivers can be downloaded from [https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers CP2102 Driver download]
* For CP2101 based SerialUSB adapters, drivers can be downloaded from [https://www.silabs.com/products/development-tools/software/usb-to-uart-bridge-vcp-drivers CP2102 Driver download]
* For initial usage, it is best to power KontroLIr with the SerialUSB adapter, until you are ready to use with batteries.
* Make sure to have 2xAAA batteries availble befor you plan to start using KontroLIR as a remote.






'''''[[KontroLIR - Arduino compatible IR remote control|> KontroLIR Home]]'''''
'''''[[KontroLIR - Arduino compatible IR remote control|> KontroLIR Home]]'''''

Revision as of 05:45, 6 October 2019

> KontroLIR Home

Follow this section the first time you get your KontroLIR remote control.


Checklist

  • Make sure you have s SerialUSB adapter which has a pinout for Vcc, GND, Tx, Rx and either DTR or RTS. (Note: some adapters do not have the DTR/RTS pin available, which is required for uploading firmware)
  • Make sure you have a USB cable to use with the serialUSB adapter.
  • Double check your order to establish if you have one or more of the options (EEPROM or dual IR Receivers)
  • If you ordered the SerialUSB adpater, then it will be compatible with KontroLIR.
  • For CP2101 based SerialUSB adapters, drivers can be downloaded from CP2102 Driver download
  • For initial usage, it is best to power KontroLIr with the SerialUSB adapter, until you are ready to use with batteries.
  • Make sure to have 2xAAA batteries availble befor you plan to start using KontroLIR as a remote.


> KontroLIR Home