Oscillator Clock Rate: Difference between revisions

From AnalysIR WiKi
Jump to navigation Jump to search
mNo edit summary
mNo edit summary
Line 1: Line 1:
[[KontroLIR - Arduino compatible IR remote control|=> KontroLIR Home]]
The clock rate can be set to '''8Mhz''' or '''4MHz''' using the Arduino IDE.
The clock rate can be set to '''8Mhz''' or '''4MHz''' using the Arduino IDE.


Line 6: Line 8:


Thus we strongly suggest using '''8MHz''' as the default clock rate, which provides a good balance between IR performance and battery rate. If you know your way around low power operation & want to drain the last bit of juice from the batteries ,then it is Ok to consider 4MHz. In our opinion, it would be preferable to swap out the batteries a little sooner and enjoy the better IR performance/experience.
Thus we strongly suggest using '''8MHz''' as the default clock rate, which provides a good balance between IR performance and battery rate. If you know your way around low power operation & want to drain the last bit of juice from the batteries ,then it is Ok to consider 4MHz. In our opinion, it would be preferable to swap out the batteries a little sooner and enjoy the better IR performance/experience.
[[KontroLIR - Arduino compatible IR remote control|=> KontroLIR Home]]

Revision as of 04:26, 6 October 2019

=> KontroLIR Home

The clock rate can be set to 8Mhz or 4MHz using the Arduino IDE.

Using 8Mhz will provide the best IR performance, while 4MHz may provide a longer battery life. Do not use any other clock rate.

Note: The granularity of the micros() function, increases as the clock rate changes from 16MHz to 8MHz to 4Mhz to 1Mhz. This has a knock on effect on the IR signals timing. Running on batteries, 16MHz is out of spec & at 1Mhz the IR performance is materially impacted by the granularity of the Arduino timing.

Thus we strongly suggest using 8MHz as the default clock rate, which provides a good balance between IR performance and battery rate. If you know your way around low power operation & want to drain the last bit of juice from the batteries ,then it is Ok to consider 4MHz. In our opinion, it would be preferable to swap out the batteries a little sooner and enjoy the better IR performance/experience.

=> KontroLIR Home