Oscillator Clock Rate

From AnalysIR WiKi
Revision as of 11:08, 8 July 2019 by AnalysIR (talk | contribs) (Created page with "The clock rate can be set to 8Mhz or 4MHz using the Arduino IDE. Using 8Mhz will provide the best IR performance, while 4MHz may provide a longer battery life. Do not use any...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

The clock rate can be set to 8Mhz or 4MHz using the Arduino IDE.

Using 8Mhz will provide the best IR performance, while 4MHz may provide a longer battery life. Do not use any other clock rate.

Note: The granularity of the micros() function, increases as the clock rate changes from 16MHz to 8MHz to 4Mhz to 1Mhz. This has a knock on effect on the IR signals timing. Running on batteries, 16MHz is out of spec & at 1Mhz the IR performance is materially impacted by the granularity of the Arduino timing.

Thus we strongly suggest using 8MHz as the default clock rate, which provides a good balance between IR performance and battery rate. If you know your way around low power operation & want to drain the last bit of juice from the batteries ,then it is Ok to consider 4MHz. In our opinion, it would be preferable to swap out the batteries a little sooner and enjoy the better IR performance/experience.